Inserting cables

  1. Use a suitable to tool to cut the required cable inlet out of the wallbox. Cable inlets are located on the rear, bottom and top.
  2. Insert the appropriate membrane cable entry (included in the scope of delivery) into the respective cable inlet.

    For cable inlet on the top or bottom:
    Use membrane cable entries with strain relief.

    For cable inlet on the rear:
    Use membrane cable entries without strain relief.
  3. Insert the cables into the wallbox. To do this, a hole must be pierced in the membrane.

  1. POSSIBLE DAMAGE

    Schaden_moeglich

    Damage to the device due to rainwater ingress

    To prevent rainwater from entering, the hole in the membrane should not be any larger than the cables. The electronic components may experience subsequent damage.

  2. Cable routing complete.