Energy meter settings

Settings on a KOSTAL Energy Meter (KEM)

If a KOSTAL Energy Meter (KEM) is used, no further settings are required.

 

Settings on a KOSTAL Smart Energy Meter

By default, no changes need to be made to the RS485 interfaces if the default settings for the RS485 interfaces are used. These are preconfigured as follows upon delivery.

 

The following devices can be connected to the RS485 interfaces:

If changes need to be made to the settings, carry out the following steps:

  1. Access the web interface of the KOSTAL Smart Energy Meter.
  2. Open the Modbus configuration under Modbus settings.
  3. Select and activateRS485 interface A or B.
  4. Under Default settings, select the inverter from the drop-down list, e.g. PLENTICORE / PIKO IQ.
    When an inverter is selected, the predefined default values are applied. These can be adjusted if necessary.
  5. Click the Save button to apply the settings.
  1. The settings for the RS485 interface have been completed.