Configuring settings in the Webserver

After commissioning, further settings can be configured using the KOSTAL Smart Energy Meter’s online interface.

To do this, use your PC or tablet to log in to the KOSTAL Smart Energy Meter. You will find a detailed description in Operation.

INFO

To log in, you will need the password from the energy meter’s type plate, which can also be found on a separate instruction leaflet in the packaging.

• The following settings should be configured by the installer after the initial commissioning:
• Configure prescribed settings relating to the grid feed-in/power limitation specified by the energy supply company (e.g. for dynamic limitation for PIKO 4.2-20, PIKO EPC and for multiple-inverter connection of solar inverters) if this has not already been done in the inverter.
• Log in to the KOSTAL Solar Portal. In this case, the measurement data is transmitted from the KOSTAL Smart Energy Meter to the portal.

• INFO

  

  The installer will need to log in to the KOSTAL Solar Portal for the PIKO MP plus with battery, for KOSTAL solar inverters in a multiple-inverter connection and for the ENECTOR wallbox.

• Set date/time zone
• Update device firmware Updating device firmware
• Change password of KOSTAL Smart Energy Meter. This can be done by going to Profile > Change password Change password