Updating software

If the manufacturer has updated software for the inverter, this can be loaded into the inverter. The software is updated to the latest version. If an update is available, you will find this on the manufacturer's website in the download area or you can start the update directly via the KOSTAL PIKO CI Conf Tool app.

Procedure

Use a smartphone or tablet with the KOSTAL PIKO CI Conf Tool app installed. Proceed as follows:

  1. Launch the app.
  2. For the update to be imported, the user must be changed. Go to Settings > User management > Change User.
  3. Go to Login as installer and enter the relevant password.

  4. INFO

    Info

    The default password for the installer/administrator is superadmin.

    With this user, a variety of settings can be configured vis-à-vis the system operator, such as network settings, power limitations or grid guidelines.

    This password should be changed after the initial commissioning. If you forget your password, it can be reset via the service.

  5. Go to Settings > Basic settings > Update CSB firmware.
  6. The inverter automatically finds the update file (G711-xxxxxxx.bin) and starts the installation.
  7. After the installation, wait approx. 2 minutes before installing the control board update.
  8. Go to Settings > Basic settings > Update CB firmware.
  9. The inverter automatically finds the update file (m_G9511-xxxxxxx.bin) and starts the installation.
  10. Check the version of the software in the app under Settings > Basic settings.
    Firmware version:
    Shows the safety firmware version.
    Internal code:
    Shows the control board (CB) firmware version, e.g. 010808 = V1.8.8
    Communication board version:
    Shows the communication board (CSB) firmware version, e.g. 010806 = V1.8.6
  1. The update has been installed.