Logging in as an installer

Once the KOSTAL PIKO CI Conf Tool app is connected to an inverter, you can see all the values. However, some settings can only be changed by an installer/administrator. This requires a change of user.

To do this, proceed as follows:

  1. In the app, select the Settings page.
  2. On the Settings page, the app shows you various menus where you can configure settings.
  3. In order to have access to all relevant settings, go to User management and then touch the Change user button.
  4. Select Installer.
  5. Enter the password and select Login .

  1. INFO

    Info

    The default password for the installer/administrator is superadmin.

    With this user, a variety of settings can be configured vis-à-vis the system operator, such as network settings, power limitations or grid guidelines.

    This password should be changed after the initial commissioning. If you forget your password, it can be reset via the service.

  2. You are now logged in as an installer.

Configuring settings

Now configure the settings of the inverter as required.