Installing PV plug connectors

DANGER

Risk of death due to electrical shock and discharge!

Disconnect the DC cables by interrupting the connections to the PV modules.

If it is not possible to disconnect the DC cables, observe the rules for working under voltage.

Use personal protective equipment, hard hat, visor or goggles, protective suit, insulating gloves.

Use an insulating protective mat as an underlay.

Only use insulated tools.

Strip approx. 9 mm of insulation off the solar cable.
Insert stripped wire end into crimped neck of contact.
Crimp the contact with a suitable crimping tool.
Insert contact into plug connector until the contact clicks into place tangibly and audibly.
INFO
Once snapped into the housing, the contact cannot be removed from the plug connector.
Tighten nut on plug connector (3 Nm).