Switching on the inverter

  1. Activate supply voltage via the line circuit breaker.
  3. Move the DC switch on the inverter to ON.

  4. INFO

    Info

    As soon as one of the two DC switches on the PIKO CI 50/60 is set to ON, the inverter starts up.

    The DC switch SW1 switches the DC inputs DC2-8. Block diagrams

    The DC switch SW2 switches the DC inputs DC10-16. Block diagrams

  5. The inverter starts up.
  6. The LEDs light up briefly during start-up.
  7. After startup, the LEDs indicate the operational status of the inverter.

  1. INFO

    Info

    When the inverter is commissioned for the first time, it goes into the Off (Shutdown) status.

    When this happens, first carry out initial commissioning.

  2. The inverter is in operation.