KOSTAL PIKO CI app - menu structure
Deviations due to software versions are possible.
Event messages
Level 1 |
|---|
Event messages information |
Generation
Level 1 |
|---|
Day/month/year energy |
Basic settings
Level 1 |
|---|
Basic information |
Type |
Serial number |
Firmware version |
Internal code |
Modbus version |
Communication board version |
Update CSB firmware |
Update CB firmware |
Operation |
Switch on the inverter |
Switch off the inverter |
Reset to factory settings |
Activate external shutdown |
Data management |
Export event messages |
Export generation data |
Export configuration |
Configuration import |
About |
App version |
User management
Level 1 | Level 2 |
|---|---|
Change user | Log in as installer |
Log in as system operator | |
Forgotten installer password (reset) | |
Change installer password for login (only possible by installer) |
|
Communication settings
Level 1 | Level 2 |
|---|---|
WLAN settings | WLAN IP |
Select WLAN connection | |
Change local WLAN password | |
LAN settings | IP mode |
IP address | |
Subnet mask | |
Router/gateway | |
Auto DNS | |
DNS server 1 | |
DNS server 2 | |
RS485 settings | Baud rate |
Data bit | |
Stop bit | |
Parity bit | |
Terminating resistor | |
Modbus address | |
Master/slave settings | Master/slave settings |
Inverter settings
Level 1 | Level 2 | Level 3 |
|---|---|---|
Time setting | Synchronize inverter time |
|
Grid settings | Frequency monitoring of level 1 activated |
|
PV string monitoring |
| |
Grid guideline |
| |
Start up time (s) |
| |
Start up time following grid error (s) |
| |
Power gradient (%/min) |
| |
Power gradient following grid error (%/min) |
| |
Overfrequency limit value x (Hz) |
| |
Underfrequency limit value x (Hz) |
| |
Overvoltage limit value x (V) |
| |
Undervoltage limit value x (V) |
| |
Overfrequency switch-off time x time (s) |
| |
Underfrequency switch-off time x time (s) |
| |
Overvoltage switch-off time x time (s) |
| |
Undervoltage switch-off time x time (s) |
| |
Max. grid start voltage (V) |
| |
Min. grid start voltage (V) |
| |
Max. grid start frequency (Hz) |
| |
Min. grid start frequency (Hz) |
| |
Moving average |
| |
Power adaptation/controls | Active power control | P(U) regulation |
P(F) regulation | ||
Power gradient (%/s) | ||
Maximum active power (%) | ||
Maximum feed-in capacity (W) | ||
With P(U) regulation active | ||
P(U) start voltage node x (V) | ||
P(U) power gradient node x Power (%) | ||
P(U) set time (S) | ||
With P(F) regulation active | ||
P(f) overfrequency gradient (%) | ||
Activation frequency (Hz) | ||
Deactivation frequency (Hz) | ||
P(f) underfrequency gradient (%) | ||
Reactive power control | Settling time of reactive power | |
Reactive power mode | ||
Energy management | Power limitation function | |
Sensor position | ||
Modbus address of energy meter | ||
Limitation of the active power to (W) | ||
IP address of energy meter | ||
L1-3 grid power | ||
Total energy | ||
Total feed-in energy | ||
L1-3 consumer power | ||
Total consumption | ||
L1-3 inverter output | ||
Total inverter output | ||
Ripple control receiver (RCR) | Activate ripple control receiver | |
RCR active power (%) | ||
RCR reactive power (%) / power factor cos phi | ||
Other settings | Isolated network detection |
|
Residual current monitoring |
| |
Type A RCD compatible |
| |
Shadow management |
| |
Shadow management interval time (s) |
| |
Insulation resistance (kOhm) |
| |
Leakage current limit (mA) |
| |
Limit for unbalanced voltage (%) |
| |
Dynamic grid support (FRT = Fault Ride Through) | Positive sequence K factor | |
Negative sequence K factor | ||
Monitoring of supply voltage | ||
Undervoltage ride through (V) UVRT | ||
Overvoltage ride through (V) OVRT | ||
Grid support mode | ||
Limited grid support (%) | ||
Irregular voltage change (%) | ||
| Overvoltage protection monitoring |
|