Webserver menu – Current values

Menu items to display the current energy values of the AC and DC side.

 

Shows the current status of the inverter, current performance data of the grid side (AC) and how the energy is distributed to the phases.

Parameter

Explanation

Status

Inverter operational status.

For more information, see Operational status (display)

Digital inputs

Signal status of digital interface terminal for ripple control receiver (input 1-4). The display shows whether the feed-in is currently limited, e.g. by the energy supplier or by an external battery management system. Settings, e.g. for user-defined active/reactive power reduction, can be made by going to Service menu > Digital inputs. Why active power control?

Output power

Shows how much inverter power is being fed into the home network.

Grid frequency

Shows the current grid frequency

Cos phi

Indicates the current power factor (cos phi)

Phase x

Shows the power values per phase (x = 1, 2 or 3)

 

Shows the current performance data of the grid side (AC).

Parameter

Explanation

Grid

Feed-in: PV energy is fed into the public grid.

Consumption: Energy is purchased from the public grid to cover home consumption.

 

If a battery is connected to the inverter, the current battery values are displayed here.

INFO

Info

If all values are at zero, the battery is in sleep mode. You can check the status of the battery by going to Current values > Inverter.

Parameter

Explanation

Status

Charge: The battery is being charged.

Discharge: Energy is being drawn from the battery.

Battery status

Normal:
Normal state

Equalisation charge:
The battery is charged from the grid for protection.

Deep discharge protection:
The battery is charged from the grid to protect against deep discharge.

Ext. battery control:
The battery is regulated via an external control system.

Battery sleep mode:
If the battery charging status falls below the configured minimum SoC, this status is displayed and the battery is disconnected from the system. As soon as sufficient excess PV power is available, sleep mode is cancelled and the battery is switched on again.

Service charging:
Service charging can only be started by the installer.

Voltage

Shows the battery's charge/discharge voltage.

Current

Shows the battery's charge/discharge current.

Power

Shows the battery's charge/discharge power.

Charging status

Shows the battery's charging status in %.

Charging cycles

Shows the battery's charging cycles.