Configuring settings in the Webserver
After the initial installation, more settings can be made using the inverter’s menu or more conveniently via the Webserver.
To do this, use a PC or tablet to log in on the Webserver as an installer. Initial commissioning is completed.
INFO

Grid parameters, limitation parameters and parameters specified by guidelines can only be changed with a service code.
To log in as an installer, you need the master key from the inverter’s type plate and your service code, which can be requested from our service team.
Information about our service team can be found on our website at www.kostal-solar-electric.com > Service and support.
The following settings should be configured after initial commissioning:
- Get the installer to configure inverter settings.
- Get the energy supply company to configure the mandatory settings for grid feed-in.
- Log in to the KOSTAL Solar Portal, if not already done.
- Allocate a password for the plant owner.
- Update the inverter software. Updating software
- If a battery is connected, configure the battery settings (e.g. min. state of charge (SoC) in Service menu > Battery settings.
- If the battery is going to be controlled externally by an energy supply company, configure the battery control. External battery control
- Configure the ripple control receiver, if connected. Active power control
- If connected, configure the message contact for external overvoltage protection (surge protection device (SPD)).
- Configure the switched outputs (e.g. for a heat pump), if connected and being used. Switched outputs.
- Configure other settings.