Wallbox
If the PLENTICORE G3 has been configured as a host with Multi Device Control, it can control an ENECTOR G2 wallbox.
To do this, an ENECTOR G2 wallbox must first be set up in the device manager. It will then be displayed in the Wallbox menu.
You can access the interface of the connected device directly via the link in the top right-hand corner.
Information on status messages can be found at Wallbox status messages.
You can find information on Wallbox charging control in the various modes at Wallbox charging control.
Various charging modes are available for charging an electric vehicle; these can be selected using the buttons.
- Lock Mode (Wallbox locked)
- Power Mode (Standard charging)
- Solar Pure Mode (Solar charging)
- Solar Plus Mode (Solar-optimised charging)
- Time Mode (Time-controlled charging)
Click on the info icon to view details about the individual charging modes.
Charging Mode – Settings
You can configure and save the settings for the charging modes here. These buttons are not used to switch the charging mode whilst charging.
Settings can be configured for the Power Mode, Solar Plus Mode and Time Mode. Changes to the settings are applied by clicking the Save button.
No settings are required for Lock Mode and Solar Pure Mode.
Settings
In the settings, you can select the usable phases and additional settings, such as the minimum charging current for charging the electric vehicle or a charging limit.